The Guide to retrofit Bi Xenon Projector Housing in CCAG CS75

In a lot of time, many cars and truck tuning Enthusiasts upgrade their factory halogen front lights right into HID light bulb. It is a little trouble. Setting up a HID bulb, it ought to be suit with the projector as well as the ballast. While some people will certainly believe it is a bothersome. They will like to upgrade the front lights housing. One of our customers do that, He drive his CS75 for about 10,000 kilometers.

1. The new housing DRL, Hella bi xenon projector for low beam, Iwasaki D2H HID light bulb, BMC reflector for high beam of light, H1 halogen bulb and also Aozoom ballast.

2. He went to our shop to end up the modification.

3. The install steps were quite basic, it did not need great deals of complicated job to fit the projector headlight kit and also examination light beam pattern.

4. The entire accessories were all placed in the housing. Just dismantle the OEM housing as well as put the new one in it.

Open the bumper as well as take off the housing. After completing the installment, the light test is essential too. Although it did not set up a projector and light bulb, check if the lights are functioning properly. All points are done, mount the bumper right into the cars and truck and adjust the light beam pattern once again.

An auto, particularly in the evening driving, needs a safe lighting warranty, certainly, the height as well as illumination of the light should be within in an affordable array. Do not adjust the elevation of low beam too high, although you are driving with low beam, the SUV design is too high. So the low beam will certainly be emit further, that would certainly impact the safety of opposite driving.